some features of COLENTA
MEDIPHOT X-Ray Processors
|
For COLENTA, coming from the photographic materials processing market, very long media rolls processing was
always a must - roll films / cine films used for X-ray investigations can be processed with COLENTA standard X-ray film processors.
* The COLENTA roller transport system does not use spring tensioned opposed rollers or metal guides, which can cause pressure marks
and scratches on the emulsion. Any length of roll film can be processed. All transport rollers are below solution level, eliminating
crystallization and dirt build-up on the roller surface that could cause damage to the emulsion or dirt related quality problems. The
submerged rollers are designed to balance in solution consequently reducing pressure and wear on bearings - virtually eliminating
maintenance costs and extending the life of the racks.
* The COLENTA transport racks are individually identified and fitted with maintenance free inline precision gearing systems to give
trouble free operation. We know, how much our competitors are suffering by their worm gear driven transport racks.
* The COLENTA intermediate rinse baths system with squeegee rollers gives consistently clean film/paper with minimal carryover of
chemistry into the next solution, and savings in the replenishment costs and daily cleaning time. Crossover rollers located above
liquid level are designed for easy removal and cleaning.
|
Transport System Type "MP902"
for 125cm/min at 20sec Dev-Time |
|
 |
Transport System Type "MP903"
for 175cm/min at 20sec Dev-Time |
|
Transport System Type "MP937/943"
for 125cm/min at 20sec Dev-Time |
 |
|
* The COLENTA transport racks are individually identified and fitted with maintenance free inline precision gearing systems to
give trouble free operation. - We know, how much our competitors are suffering by their worm gear driven transport racks.
|
Chain Drive System
MP902 / MP903 |
Chain Drive System
MP937 / MP943 |
 |
 |
* COLENTA’s programmable, multi channel memory microprocessor controllers, used in the X-Ray Film Processors - allowing the operator
to preset exact processing datas - are activating and monitoring all functions of the processors. All indications are given on the
digital display on the CPU board of the microprocessor, where all error indications are also shown. For error indications and film feed
release an additional audible signal is available. Functions like automatic standby, water saver, antioxidation and anticrystallization
cycle, automatic start/stop function, are state of the art for COLENTA processing equipment.
* We replenish exactly according to the amount of square inches of film surface fed into the processor - we use pulsed infrared sensors
(not exposing IR-material of course) for our replenishment system, instead of mechanical replenishment switches.
Power Distrbution Board
MF800 with CPU |
Microprocessor control
Display |
Well organized/CE approved
electronicbox |
 |
 |
 |
* COLENTA’s slim roller transport rack design results in low volume tank processors - already a big move forward to forthcoming new processing
technologies - LTTV (Low Thin Tank Volume) technology. Also due to the slim COLENTA rack design, a small surface of chemistry is exposed to the
air, reducing air oxidation. Both advantages - less air oxidation and easy, quick complete turnover of the whole content of the low volume COLENTA
processor tanks by normal (or even reduced) replenishment rates - are leading to constant high quality processing results.
* The COLENTA transport racks are individually identified and fitted with maintenance free inline precision gearing systems to
give trouble free operation. - We know, how much our competitors are suffering by their worm gear driven transport racks.
We will appreciate all your comments and are ready to proceed.
|
